Gunnar Cycles USA Message Board

It is currently Tue Jul 29, 2014 7:56 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Wed Feb 23, 2011 2:58 pm 
Offline

Joined: Wed Feb 23, 2011 2:46 pm
Posts: 2
Location: United States
How is “Stack” and “Reach” listed in the Gunnar Geometries charts measured?

Is Reach horizontal distance from center of bb to center of where headtube and top tube intersect, or bb to center top of headtube, or some other point?

Same for Stack, vertical distance from center of bb to center of where headtube and top tube intersect, etc...?

Regards,
Matt


Top
 Profile  
 
 Post subject:
PostPosted: Thu Feb 24, 2011 5:50 pm 
Offline

Joined: Fri Nov 05, 2004 8:48 am
Posts: 55
Check out what Zinn has to say at:

http://velonews.competitor.com/2011/02/ ... ape_159970

Look towards middle of page


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group