Gunnar Cycles USA Message Board
http://www.gunnarbikes.com/bb/

Frame Geometry of 2000 Rockhound
http://www.gunnarbikes.com/bb/viewtopic.php?f=1&t=342
Page 1 of 1

Author:  PTDOCTOR [ Fri Feb 09, 2007 6:46 pm ]
Post subject:  Frame Geometry of 2000 Rockhound

Hi,

I am a new used Rockhound owner and was wondering if there was anywhere on the Gunnar site to get the geometry of the older bikes? Or are they exactly the same as the current? I am most interested in the length of the headtube as I am considering a used fork purchase and trying to figure out if the cut steering tube is long enough. The guy I bought the frame from said it was an 18" so I am guessing its the 17.5" . I would measure myself but it is getting powder coated. Any help is appreciated.

Thanks

Frame serial number is K00194

Author:  Dave Hellekson [ Tue Feb 13, 2007 10:56 am ]
Post subject: 

Howdy,

Your K00194 is a 19" RockHound, dressed in the original Gunnar Blue. The basic handlig geometry is the same as the current one. Enhancements have been made for fit, tire clearance, suspension forks, etc.

There were a number of tweaks made during that time. It would be best to take an actual measurement from your head tube.

Author:  PTDOCTOR [ Tue Feb 13, 2007 9:06 pm ]
Post subject: 

Thanks Dave,

A 19" frame is not the best news. I think that it might be a little big, but hopefully it will still fit.

I am 5' 10" with a 32" inseam (pants length 30). Any Rockhound owners out there that are my size that ride the 19" frame?

Thanks

Author:  rockhound [ Sat Dec 10, 2011 4:38 pm ]
Post subject:  Re: Frame Geometry of 2000 Rockhound

It sounds like it should fit fine.

Did it? (I know this post is old)

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/